Instructions for Use and Guarantee Conditions
13
IML
-Instrumenta Mechanik Labor System GmbH
I
Parkstraße 33
I
69168 Wiesloch I
Phone +49 (0) 6222 6797-0
I
Fax +49 (0) 6222 6797-10
I
E-mail [email protected]
I
Web: www.iml.de
ENGLISH
Instruction
Maintenance works
Lubrication of the gear wheels
The gear wheels will have to be checked for defects
after approximately 200 measurements.
First, disconnect the instrument from power supply
and remove the
safety cover
. In general, remove all kinds
of soil. Now, you may check the gear wheels.
Tools:
Oil can (TOOL KIT)
If the gear wheels are free from defects, slightly lubricate them.
Place the safety cover and connect the instrument to power supply.
If the gear wheels are damaged, send the instrument to the manufacturer for repair!
Replacing the safety pin
The safety pin has to be replaced, if:
-
the drilling needle does not rotate and the slide does not
move anymore!
Tools:
Hammer and pin punch
(TOOL KIT)
Remove safety covers
1
and
2
and disconnect the drill from the drive shaft.
Remove the remaining part of the safety pin by means of the pin punch supplied.
Pull the hexagon bolt out of the drive shaft.
Some of the maintenance works described below can only be carried out by means of
the professional
TOOL KIT
, which is included in the scope of delivery!
NOTE
Safety cover 2
Safety cover 1
Pin punch
& hammer
Oil can
Gear wheel
