IMI Pearlmax3, User Manual

Page: 39 / 41

Page 38
In case of a reduced performance of the carbonation module, it must be checked if any water has collected on the CO
2
gas side of the
Inline carbonation module. Under certain circumstances
(e.g. missing CO
2
pressure due to an empty CO
2
bottle or higher share of dispensed stillwater)
water can collect here, reducing the carbonation performance.
There is an optional kit available that allows the drain function to operate automaticaly via a timercontrolled solenoid.
The kit is available under partnumber 22-0105-002. Please contact your service provider in case this is required.
The inline Carbonisation module is equipped
with a drain port which is located on all
sodwater versions behind the servicedoor.
To eliminate any possible water residues, leave
the CO
2
gas supply to the unit open.
Take the stopcock from it´s fixture and unscrew
the stainless steel cap (Picture 1 and 2)
Now open the blue stopcock for 4-5 seconds
until only CO
2
gas exists. There should be no
water existing the the stopcock anymore.
Attention ! Firmly close (by hand is sufficient)
the stop cock again with the steel cap in order
to eliminate any risk of CO
2
gas loss in case
the stop cock is not closed 100% !
16. Using the drain of the Inline Carbonation Module (only valid
16. Using the drain of the Inline Carbonation Module (only valid
for units with Inline Carbonator)
for units with Inline Carbonator)
Pic 1
Pic 2