BPGS10H PNEUMATIC GRIPPER SYSTEM
User Manual
BIM-BPGS10H-0719 Rev 1 | For Technical Assistance: 800-442-4622
9
4. To secure sensor to gripper, flip over while holding sensor to ensure that bushing and drive rod are still aligned.
Clean all three M4 X 30mm SHCS for sensor and insert through gripper body and into sensor. Tighten M4
SHCS to 50in-lb.
PAD REPLACEMENT
1. Unlock jaws on gripper & open jaws to get access to the pads. Side plates DO NOT need to be removed. Refer
to "Gripper Unlock" section.
2. Remove M5X10 mm SHCS along with the 5 mm schnorr washer from jaw.
3. Apply Loctite Silver Grade Anti-Seize to M5 X 10mm SHCS. Make sure 5mm schnorr washer is used along with
M5 X 10mm SHCS before inserting into one of the jaws. Take replacement pad and insert it into the opposite side
of the jaw with the SHCS sticking out. Thread SHCS into pad and tighten to 72in-lb. Repeat step for other jaw.
