5
Connection with the mains
The earth has to be connected. The device must only be connected with an electric installation
carried out in compliance with IEC standards.
OPERATION
After you connected the effect to the mains,
t
he fixture starts running
Stand Alone operation
In the stand alone mode, the fixture can be use
d
without controller
Master/slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by
one master-device
DMX controlled operation
You can control the projectors individually via your DMX-controller
Addressing
The control board allows you to assign the DMX starting address,
Note: it’s necessary to insert the XLR termination plug (with 120
ohm) in the last device in the
link in order to ensure proper transmission on the DMX data link.
C
ontrol board
The control board offer several features. You can simple set the starting address, run
the pre-programmed program or make a reset
.
The main menu is accessed by pressing the Mode/Esc-button, Browse through the submenu by
pressing Up or Down .Press the Enter-button in order to select the desired menu. You can change the
selection by pressing Up or Down, Confirm every selection by pressing the Enter-button. You can leave
every mode by pressing the Mode/Esc-button .The functions provided are described in the following
setting.
M EN U M AP
The device has two operation modes. It can be operated in Stand Alone or in DMX controlled
When in Master/Slave Synchronization Mode, only one in a series chain can be set as the master.
The main menu is accessed by pressing the Mode/Esc-button
.
Browse through the submenu
by pressing Up or Down.
Press the Enter-button in order to select the desired menu. You can change
the selection by pressing Up or Down
.
Confirm every selection by pressing the Enter-button. You can
leave every mode by pressing the Mode/Esc-button.
The functions provided are described in the
following setting.
M E N U M A P
The device has two operation modes. It can be operated in Stand Alone or in DMX controlled
.
When in Master/Slave Synchronization Mode, only one in a series chain can be set as the master.
