All operating elements can be found on the fold-
out page 3.
1
Operating Elements
1.1 Fig. 1: Hand-held microphone
1
Microphone cartridge; to insert batteries, unscrew
the cartridge (figs. 2 to 4)
2
LC display; shows the transmission channel and
the charging status of the batteries during operation
3
Cap for the control part; remove the cap for opera-
tion (fig. 5)
4
Power switch
1.2 Figs. 2 to 4: Inserting batteries
(microphone cartridge unscrewed)
5
4-pole contact, each on the microphone cartridge
(fig. 2) and on the handle (fig. 3);
prior to assembling microphone cartridge and
handle fit the contacts together
6
Lock for the battery holder (7);
to unlock the holder, press the lock in arrow direc-
tion backwards
7
Battery holder for two 1.5 V batteries of size AA (R6)
1.3 Fig. 5: Control part
(cap removed)
8
Key “SET”
with the unit not locked:
to recall and to exit the adjusting modes for chan-
nel/sensitivity/lock function
→
chapters 5.1, 5.2, and 5.3.1
with the unit locked:
to recall and to exit the adjusting mode for the
lock function
→
chapter 5.3.2
9
Key
for channel selection “down” (in the channel
adjusting mode), to reduce the sensitivity (in the
sensitivity adjusting mode), and to deactivate the
lock function (in the lock mode)
10
Key
for channel selection “up” (in the channel
adjusting mode), to increase the sensitivity (in the
sensitivity adjusting mode) and to activate the lock
function (in the lock mode)
2
Important Notes
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient temperature
range 0 – 40 °C).
G
For cleaning only use a dry, soft cloth, by no means
chemicals or water.
G
No guarantee claims for the unit and no liability for
any resulting personal damage or material damage
will be accepted if the unit is used for other purposes
than originally intended, if it is not correctly operated
or not repaired in an expert way.
3
Applications
In combination with the 2-channel multifrequency re -
ceiver TXS-892 from “img Stage Line” this dynamic
hand-held microphone with integrated multifrequency
transmitter makes up a wireless audio transmis-
sion system. Within the UHF frequency range of
740 – 764 MHz, the transmission channel can be se -
lected among 16 channels as desired.
The microphone is supplied with a microphone
case, a microphone holder, and 7 push-on caps of dif-
ferent colours.
3.1 Conformity and Approval of the wireless
microphone
Herewith, MONACOR INTERNATIONAL de clare that
the unit TXS-892HT is in accordance with the basic
requirements and the other relevant regulations of
the directive 1999 / 5 / EC. The declaration of conformity
can be found in the
Internet via the MONACOR
INTERNATIONAL home page:
www.imgstageline.com
This unit may be operated in the following countries:
DE
The regulations of the country where this unit is oper-
ated must always be observed. These regulations can
be found via links to the national authorities from the
following Internet address:
www.ero.dk
4
Power supply
G
Insert only batteries of the same type and always
replace all batteries.
G
If the unit is not used for a longer period (e. g. more
than a week), remove the batteries. Thus, the unit
will not be damaged in case of battery leakage.
1) Unscrew the microphone cartridge (1).
2) To unlock the battery holder (7), press the lock (6)
in arrow direction backwards.
3) Remove the battery holder up to the stop (fig. 4)
and insert two 1.5 V batteries of size AA (R6) with
the positive and negative connections as indicated
in the holder.
If the unit is to be put out of operation defini -
tively, take it to a local recycling plant for a
disposal which is not harmful to the environ-
ment.
Do not put exhausted batteries/defective rechargea-
ble batteries into the household rubbish but take
them to a special waste disposal (e. g. collective con-
tainer at your retailer).
GB
7
