iMettos B10, Instruction Manual

Page: 8 / 18

7
2 Splash shield 8 Agitator
3 Bowl lift handle 9 Beater Shaft
4 Rear bowl location pin 10 Guard
5 Bowl Support 11 Attachment hub cover
6 Side bowl pin
IMPORTANT NOTES
1. Before use, check whether the power supply corresponds to that required by the machine and check whether the
external earthing wire is reliably connected.
2. The direction of rotation of a machine with a 3-phase motor must firstly be checked. If the direction of rotation is
opposite of that indicated by the rotation mark, then two of the three livewires should be switched with each other.
Please note, mixing tools should not be installed during this test, otherwise they will fall out in the case of the wrong
direction of rotation and cause damage to the machine parts.
3. For every power educe line which has not attach plug, should be connected to the switch of at least 3mm touch-point
distance which installed by user. Rated current of the switch must not be lower than 35A
When installing the blender, stir-axis gear must be a good size with the stirrer crossing in place to prevent falling
Trouble shooting
Trouble Probable cause Remedy
The mixing shaft do not rotate
after switch on Electric connectors are loose Check the electric circuit, tighten those
loose connectors
Oil leakage Oil seals are worn out Replace those oil seals
The raising handle is too tight Guide ways are corroded Clean and oil the guide ways
The lead screw, bevel gear and hand wheel
shaft etc. is dry Oil them
Temperature rise of motor is too
high, below speed Lack of voltage Check the supply voltage
Over load Less load
The working speed selected is too high or
agitator is not suitable Select a suitable speed and agitator
7. INSTALLATION
A qualified person must install this machine in accordance with current regulations
7.1. UNPACKING AND HANDLING
Wherever possible, the mixer should be transported to the installation position in the packaging provided to avoid any
damage. Do not use a sharp knife to open the box to prevent damaging the machine. On first inspection, check for any
possible shipping damages. If any damage has been found, save the packaging material and contact us.
Caution: The mixer is a heavy object and must be correctly handled and lifted to avoid any and all personal injuries.
With the machine in the vicinity of its final position remove from the transportation pallet. The machine is affixed to the
pallet by four retaining bolts through the pallet into the threaded feet of the base. Care must be taken during this
operation to ensure: