The Manual of Ink-jet Printer
7
Install & Test
Only trained technicians are authorized to carry out installation.
Before install, confirm the machine was stay in a solid & smooth place without electromagnetic radiation.
Installed as stipulated in manufacturer’s specification, do not change the relative position of ink system and
print head. Any special requirements, please consult the manufacturer and supplier directly.
Ink-jet Printer Installation & Testing
Photo1
1
、
Unpacking: open the package and move out print head, host machine, suspension pad etc.
2
、
Suspension Pad Installation: 1) fix pads into triangle stands with same height. 2) adjust the three pads
so as to keep the triangle stand in vertically. 3) fasten the three screw nuts with the spanner.
3
、
Ink tank installation: 1) Put small steel pipes into large ones and put large steel pipes into triangle
stands, after adjusted the height, fasten the star like screw.2) Put the two-hole aluminum stand in
profile of ink tank system into small steel pipe, and then fasten by star like screw.
4
、
Host Machine Installation: Put the two-hole aluminum stand in profile of host machine into small steel
pipe, and then fasten by star like screw.
5
、
Print head Installation: 1) put the aluminum stick into the two-hole aluminum stand, and fastened by
star like screw. 2) Screw the print head on aluminum stick. 3) connect one side of ink tube to filter and
the other side to ink inlet.
