DTD-5230, DTD-5231, and DTD-5233 Installation and Operation Manual
5
Chapter 2: Installing the DTD-523x
Rear Panel Installation
The rear panel has two connectors (see Figure 3-1 on page 3-8).
Depending on the configuration, these connectors either accept or
output serial timecode (SMPTE or EBU). All clocks are shipped
configured for timecode input (slave) operation, unless otherwise
specified when ordering. A label indicates whether the clock is in
Master or Slave configuration.
A standard AC power connector and cord are included.
Input Switch Functions
The DIP switch at the rear of the DTD-523x unit is used to configure
many of the operational parameters of the unit. All switches enable their
corresponding function when in the up position.
See “Setting the Control Mode” on page 8 for details on DIP switch
operation.
Power Supply
The power consumption of the DTD-523x is 6 W at nominally
100-120/200-240 VAC (0.25/0.15 A max.), 50/60 Hz. In order that the
unit operates with maximum stability, it is recommended that the power
be applied 24 hours a day.
