AES
Installation and Operation Manual
7
Installing AES Modules
AES products can be installed in an FR6822
+
QXFE frame, or an FR6822
+
F frame
containing a 6800+ETH module, except in slots 6 and 14.
When installing both front and rear modules together, ensure that the back module is
installed first before plugging in the front module. During
removal
, ensure that the
front
module is unplugged from the frame first, before removing the rear module. Do not mix
AES front and back modules.
-BD
,
-CD
, and
-CDL
back modules must be
matched with their own front modules.
Any unused loop outputs on the
-CDL
back should have a 75
Ω
termination.
See your
Frame Installation and Operation Manual
for general information about installing
back modules in a frame.
CAUTION: Before installing this product, read the
6800
+
Series Safety Instructions
and Standards Manual
available on our website, or on the
Harris Infrastructure and
Networking Documentation DVD
. This safety manual contains important
information about the safe installation and operation of 6800
+
series products.
Upgrading Module Firmware
This module’s firmware can be updated using CCS Navigator version 4.7 or higher, or the
HTTP software upgrade tool. In order to perform these upgrades, the frame must be
equipped with a 6800
+
ETH module, version 4.7 or higher. See your frame manual for more
information.
Operating Notes
When setting the control parameters on the AES, note the following:
If you make changes to certain parameters, other related parameters may also be
affected or become disabled. See
AES Control Parameters
on page 16 for
more information.
When you change a parameter, the effect is immediate. However, the module requires
up to 30 seconds to save the latest change. After 30 seconds, the new settings are
saved and will be restored if the module loses power and must be restarted.
When you set the
Factory Recall
parameter to
Yes
, the module takes several seconds
to reset all of the parameters to their default settings.
