8
13. Apply a thin film of grease to the shaft of a Bolt Set
(27) and the post on the left Crank Arm (36).
Slide the Left Pedal Arm (14) onto the post on the left
Crank Arm (36). Attach the Left Pedal Arm with an M8
x 19mm Button Screw (22), an M8 Large Washer
(17), and a Wave Washer (94). Make sure the Wave
Washer is on the post before tightening the Button
Screw.
Attach the Left Upper Body Leg (73) to the Left Pedal
Arm (14) with the Bolt Set (27).
See step 6 on page 6. Tighten the M8 x 42mm Button
Bolts (50).
Make sure that the M8 Nylon Locknuts
(46) are seated in the hexagonal holes.
Attach the Right Pedal Arm (16) to the right side of
the elliptical exerciser in the same way.
14.
Make sure that all parts of the elliptical exerciser are properly tightened.
Place a mat under the elliptical
exerciser to protect the floor or carpet from damage.
36
14
94
17
22
27
73
16
13
Grease
Grease
12
20
74
74
13
14
12. Identify the Left Pedal (13), which has an “L” molded
into its bottom surface, and the Left Pedal Arm (14),
which is marked with a sticker.
Attach the Left Pedal (13) to the Left Pedal Arm (14)
with two M8 x 48mm Button Screws (20) and two M8
Split Washers (74).
Attach the Right Pedal (not shown) in the same way.
