6
87
82
82
38
25
Tube
9
90
93
23
10
88
91
93
26
2
7
5. Hold the Console Bracket (26) near the Upright (2),
and locate the wire extending from the bottom of the
Console Bracket. Carefully pull the upper end of the
Upper Wire Harness (79) to remove any slack, and tie
the wire around the Upper Wire Harness, as shown in
the inset drawing. Carefully pull the wire up through
the Console Bracket until the Upper Wire Harness is
extending from the top of the Console Bracket. Then,
untie the wire and discard it.
Insert the Console Bracket (26) into the Upright (2).
Be careful to avoid pinching the Upper Wire
Harness (79).
Attach the Console Bracket with three
M8 x 25mm Button Screws (57) and three M8 Split
Washers (74).
5
26
79
2
57
57
74
74
79
Wire
9
73
46
Tube
Hexagonal
Holes
50
6. Identify the Left Upper Body Arm (9) and the Left
Upper Body Leg (73), which are marked with stickers.
Insert the Left Upper Body Arm (9) into the Left Upper
Body Leg (73).
Make sure that the short tube on
the Left Upper Body Arm and the hexagonal holes
in the Left Upper Body Leg are on the same side.
Attach the Left Upper Body Arm with two M8 x 42mm
Button Bolts (50) and two M8 Nylon Locknuts (46).
Do not tighten the Button Bolts yet.
Attach the Right Upper Body Arm (not shown) to the
Right Upper Body Leg (not shown) in the same way.
6
7. Insert the Pivot Axle (38) into the Upright (2), and cen-
ter the Pivot Axle. Apply a generous amount of the
included grease to the Pivot Axle.
Identify the Left Upper Body Arm (9), which is marked
with a sticker. Slide a Handlebar Spacer (25) onto the
short tube on the Left Upper Body Arm. Slide the Left
Upper Body Arm onto the Pivot Axle (38).
Orient a Handlebar Cap (23) as shown, and slide it
onto the lower end of the Left Handlebar (87). Slide the
upper end of the Left Handlebar (87) into the tube on
the front of the Console Bracket (26), while sliding the
lower end of the Left Handlebar onto the Pivot Axle
(38). Attach the upper end of the Left Handlebar with
two M8 x 41mm Button Bolts (91) and two M8 Jam
Nuts (93);
make sure the Jam Nuts are resting in
the hexagonal holes in the Console Bracket.
Attach the lower end of the Left Handlebar with an M8
x 35mm Button Bolt (90) and an M8 Jam Nut (93).
Then, press the tabs on the Handlebar Cap (23) into
the Handlebar Spacer (25).
Assemble the Right Upper Body Arm (10) and the
Right Handlebar (88) in the same way.
Gently separate the two Upright Covers (82). Hold the
Upright Covers around the Upright (2), and firmly
press the Upright Covers together.
Grease
Tab
