Imada ZTS series, Instruction Manual

Page: 33 / 44

11 REFERENCE SECTION — PROGRAM MENU
1/6
page 34
High Low Setpoints
High/Low setpoints enable Go/No Go tests. Orange
LED lights for values under the low setpoint (–NG),
green lights for values within low and high (OK),
and red lights for values over high (+NG). See page 8.
1. Turn ON the gauge, then press and hold
MENU
two seconds to
enter the Program Menu. High/Low Setpoints, is highlighted, press
the right arrow key to select.
2. High is highlighted; press the right arrow key to select.
3. Press the up/down arrow keys to change the High value and
press
MENU
to input your selection.
4. Press the down arrow key to highlight Low, then press the right
arrow key to select.
5. Press the up/down arrow keys to change the Low value and
press
MENU
to input your selection.
6. Press the left arrow key until the door icon
#
appears, then press
and hold
MENU
two seconds to exit. Or press the left arrow
key and when ‘Exit Menu’ appears, press
MENU
to exit.
1
Peak Functions
[and][or] Peak
Factory Default=‘Or’
‘Or Peak’ captures peak compression OR tension.
‘And Peak’ captures both compression AND tension
peaks. See page 10 for instructions.
1. Turn ON the gauge. Press and hold
MENU
two seconds to enter
the Program Menu. Press down arrow key to highlight Peak
Functions then press the right arrow key to select.
2. [and][or] Peak is highlighted; press the right arrow key to select.
3. Press the up/down arrow keys to select and press
MENU
to
input your selection.
4. Press the left arrow key until the door icon
#
appears, then press
and hold
MENU
two seconds to exit. Or press the left arrow
key and when ‘Exit Menu’ appears, press
MENU
to exit.
2
Program Menu
Date and Time
# High Low Setpoints >
Peak Functions
Program Menu
High Low Setpoints
# Peak Functions >
Internal Memory