ILVE RTM62, Instruction Manual

Page: 5 / 19

4
Any changes that may be necessary to the electrical system to install the product must be
performed by competent persons only. Repairs carried out by unskilled persons can cause
damage. For eventual interventions, contact a Technical Assistance Center authorized to
replace the spare parts.
If the power cord or other components are damaged, the appliance must NOT be used:
disconnect the appliance from the power supply and contact the dealer or an authorized
Technical Assistance Center for repair.
II
INSTALLATION WARNINGS
Warning! It is recommended to identify a position sheltered from
rain, snow, wind, etc. to avoid water and moisture infiltration inside
the appliance that could damage it.
Warning! Do not connect the appliance to flue gas exhaust pipes (e.g.
boilers, fireplaces, etc.).
Before installing the appliance, make sure that all the regulations in
force concerning the discharge of the air outside the room are
respected. In case of simultaneous use of other utilities (boilers, stoves,
fireplaces, etc.) powered by gas or other fuels, provide adequate
ventilation of the room where the fumes are sucked in, according to
current regulations.
III
INSTALLATION
Read the entire instruction manual before installing and using the equipment.
The device is equipped with all the fixings necessary for its installation and suitable for
most situations.
The product can be installed in different configurations for wall and island hoods Fig. 01,
02, 03 at a distance not exceeding 7 meters, which corresponds to the length of the
connection cable.
Use pipes with a diameter of no less than 150mm and a number of curves not beyond the
indispensable.
The horizontal sections of the pipeline must have a slight inclination to prevent
condensation from reflow in the engine and the electrical parts.