ILVE RTM62, Instruction Manual

Page: 12 / 19

11
IV
ELECTRICAL CONNECTION
The electrical connection must be performed ONLY by specialized technicians.
The electrical protection of the electrical connection upstream of the appliance must
comply with the regulations in force.
Warning! Make sure that the voltage (V) and frequency (Hz) indicated
on the serial number plate inside the fixtures correspond to those
available at the installation place.
Any changes that may be necessary to the electrical system to install the device must be
performed only by competent persons.
After installation, the isolated parts and those carrying electric current must be protected
from any contact.
Warning! If the electrical connection is performed incorrectly or not
in accordance with the regulations, parts of the appliance may be
damaged and the warranty will not be accepted.
Warning! Before each intervention, disconnect the appliance from
the mains (Fig.1-2 chapter WARNINGS).
The earth connection (yellow-green cable) must under no circumstances be
interrupted.
This appliance must be connected to a hood prepared without an aspirator for this type of
device as shown in Fig. 09 and 10.
The device will then be powered and controlled directly by the hood.
For stationary appliances permanently connected to the fixed wiring, compliance
with this requirement is considered to be met if the instruction concerning
disconnection incorporated in the fixed wiring is in accordance with AS/NZS
3000