ILVE ILEM46, Instruction Manual, Page: 17 / 33

EN
16
10 - Preparing coffee with pre-ground coffee (instead of beans)
11 - Delivering hot water
12 - Rinse function
13 - Changing the quantity of hot water
• Press the (B4) icon (B4) (fig. 8) and select the pre-
ground coffee function.
• Extract the machine by pulling it outwards using the
handles (fig. 7).
• Lift the central lid, place one measure of pre-ground coffee
in the funnel (fig. 19), push the appliance in then proceed
as described in the section “Making coffee using coffee
beans”.
N.B.: You can make just one coffee at a time by pressing
the icon (B10) (fig. 12).
• After using the machine with pre-ground coffee, to go
back to making coffee using beans, deactivate the pre-
ground coffee function by pressing the icon (B4) (fig.
8).
NOTE 1: Never introduce pre-ground coffee when the
machine is off or it could spread through the
inside of the appliance.
NOTE 2: Never add more than 1 measure, otherwise the
appliance will not make the coffee.
NOTE 3: Use the measure provided only.
NOTE 4: Introduce only pre-ground coffee for espresso
coffee machines into the funnel.
NOTE 5: If more than one measure of pre-ground coffee is
used and the funnel clogs, push the coffee down
with a knife (fig. 21) then remove and clean the
brewing unit and machine as described in the
“Cleaning the brewing unit” section.
• Always make sure the appliance is ready.
• Place a container under the hot water spout (fig. 5).
• Press the icon (B13) (fig. 20). The appliance displays:
“HOT WATER PRESS OK”. Press the OK icon (B9) again
and hot water is delivered from the cappuccino maker
into the container underneath. (You should not deliver hot
water for more than 2 minutes at a time). To interrupt,
press the icon (B13) or the icon (B6).
The appliance stops delivery once the set quantity is
reached.
Press the button (B3) to start the “rinse” function. Press the
key (B6) to cancel the function at any time.
The machine is set by default to automatically delivery 200
ml of hot water.
To change these quantities, proceed as follows:
• Place a container underneath the cappuccino maker (fig.
5).
• Press the (B2) to enter the menu (fig. 15) or press the
icons (B7) and (B8) (fig. 2) until “PROGRAM HOT
WATER” is displayed.
• Press the OK icon (B9) to confirm.
• Select the required quantity of water by pressing the
icons (B7) and (B8). The progress bar shows the quantity
of water selected.
• Press the OK icon (B9) to confirm (or the icon (B6) to
cancel the operation.
• Press the (B6) icon (B6) (fig. 18) twice to exit the
menu.
• The appliance is now reprogrammed with the new settings
and is ready.