Page 4 of 7
4. INSTALLATION OF ILOQ D5S.5X0 SERIES
Please note that the below displayed key switch act only as a demonstrator to get an idea how to install the
cylinder. Different key switches are available in the market, for additional (installation) information please see
also the documentation from the key switch manufacturer.
A. Ensure the cam is pointing downwards, otherwise see chapter 0. CAM ADJUSTMENT.
B. Slide the lock cylinder through the key front plate (and cover if applicable).
C. Fix the cylinder into the front plate by using an iLOQ fixing screw A10.64 or with the screw
shipped with the key switch. If necessary, cut the screw. Use a tightening torque of 0.9...1.1
Nm.
D.
Adjust the cam to the correct position (in a way that the cam can operate the
switches after engaging and turning the knob (but without touching the switch) and will
block the adapter inside the key switch).
E.
Check if the switch is in place and secured, and then move the cylinder with the front plate
back inside the switch and the housing.
F.
Activate the cylinder by using a Smartphone or Key Fob (with access rights) to test if the
combination is working properly.
G.
Turn the knob to the end of the opening position and release the knob
H.
Fix the front plate/cover with the screw / the screws.
A
B
D
E
F, G, H
C