Page 3 of 7
1. BEFORE INSTALLING
1. These instructions should be carefully followed during installation. These instructions and
any maintenance instructions should be passed on by the installer to the user.
2. iLOQ D5S cylinders must be installed and used carefully without excessive force.
3. The product should not be modified in any way except in accordance with the modifications
described in these instructions.
4. Care should be taken to ensure that any seals or weather-stripping fitted to the complete
door assembly, does not inhibit the correct operations of D5S cylinder.
5. Care should be taken to ensure that no projection of the D5S cylinder and associated parts,
can prevent the door swinging freely.
6. All components necessary for the specific installation should be fitted in order to ensure
compliance with EN 15684 standard.
7. The cylinder must project less than 1 mm on outside of the door to ensure proper operation.
8. No liability is accepted for damage to the doors or components due to incorrect installation.
9. Before fitting D5S cylinder to a fire/smoke resisting door, the fire certification should be
examined, to ensure conformity.
10. D5S.5x0 cylinder is only available in one length with 30/10 mm.
11. This type of cylinder is developed for the use inside key switches which are prepared for
DIN half cylinder with a length of 30-10 mm. Do not use the cylinder for other purposes
resp. use cases.
12. The cylinder has an operating angle of +/- 90°around the neutral position
,
do not try to
overturn the cam.
13. If there are any deviations from the contents in foreign language versions of the
documentation, the English original shall apply in case of doubt.
14. We reserve the right to make modifications or further technical developments without further
notice.
2. AFTER INSTALLATION
Test the cylinder functionality after installation to ensure that it does not prevent the key switch from
working properly.
3. CARE
After 5-10,000 usages, clean contact rolls lightly with lint-free cotton pad. Spray small amount of
high-quality lock oil i.e. CRC lock oil (with PTFE) onto contact rolls.
In the case the cylinder is not working in an appropriate way anymore, we recommend cleaning the
cylinder with e.g. compressed air spray or similar.