Assembly and Installation
600072
ILMVAC GmbH
11
WARNING !
Should the user change the electrical connection, for example for fitting into a sys-
tem, then this may only be performed by a electronics expert under observance of
the accident prevention regulations.
5.3.2
Battery operation
A 9 V block battery is required for battery operation independent of the mains network, this
has to be inserted into the battery compartment on the back of the measuring device. Open
the battery compartment by lightly pressing the actuating element down and lifting the lid. At-
tach the battery to the battery clip.
1 -
Battery compartment
2 -
Actuating element
Fig. 4 Rear side of device
The use of a 9 V alkali-manganese
block battery with a capacity of
> 500 mAh is recommended.
The service life of the battery
averages 200 operating hours
(active measuring time).
Once the battery has discharged,
this is indicated by "BAT"
appearing in the display on the
measuring device.
Fig. 5 Display: Battery discharged
5.4
Scrap Disposal
CAUTION !
The Multi-Range Vacuum Gauges must be disposed of in accordance with the
2012/19/EC guideline and the specific national regulations.
Contaminated vacuum gauges must be decontaminated according to the laws.
1
2
BAT
