Illusonic IAP4, Owner'S Manual

Page: 31 / 60

Illusonic IAP 4 Chapter 3
Usage
29
PRESET 1
HDMI 1
-40.0 dB
Menu
MENU
BASS MGMT
IMMERSION
MENU
EQUALIZER
IMMERSION
MENU
INPUTS
IMMERSION
MENU
OUTPUTS
IMMERSION
MENU
SPEAKER SETUP
DISPLAY
< >
MENU
SYSTEM
DISPLAY
The figure on the left illustrates the menus of IAP 4. These are described in
detail in the following chapters:
– Chapter 4 (Menu: Speaker Setup)
In this menu you configure the Processor for your specific loudspeaker
setup. The supported loudspeaker setups are explained.
– Chapter 5 (Menu: Inputs)
This menu contains all settings related to the Processor’s inputs.
Inputs can be renamed, delays and gains can be applied to each input,
and the HDMI inputs can be configured for different audio formats.
USB, network, and phono settings can also be changed in this menu.
–
Chapter 6 (Menu: Outputs)
This menu contains settings related to the Processor’s outputs.
Here you can calibrate your system with gain and delay trims.
Also, the output limiters and channel polarity are configured here.
– Chapter 7 (Menu: Bass Mgmt)
The Processor’s bass management system is configured in this menu.
Bass management allows the use of full-range, small, or a mix of
full-range and small loudspeakers. Dedicated low frequency loud-
speakers (subwoofers) can also be used.
– Chapter 8 (Menu: Equalizer)
This menu contains settings related to the equalizers which are available
for each loudspeaker channel. These can be used for calibration of
loudspeakers near walls or behind screens, and room equalization.
–
Chapter 9 (Menu: System)
This menu contains system-related settings and information, such as
display brightness/sleep, network info, firmware version, and remote
control pairing.