illumina 20040482, Operating Manual, Page: 81 / 124

6 - Operation
Operating in Routine Operation Mode
Infinium LiHa and Infinium RoMa Operating Manual - Document # 1000000110155 v00 6 - 17
6.3.5 Checks and Terminating Tasks
Cross
References
List of cross references to information provided in other sections:
Performing the
Checks and
Tasks
1 Check if the run has been terminated without any error (check for error
messages).
2 Empty and clean the reagent troughs.
3 Empty and clean the waste container and rinse it with ethanol.
Refer to cross references above.
6.3.6 Switching the Instrument Off
Cross
References
List of cross references to information provided in other sections:
Before switching the instrument off, some maintenance tasks might need to be
performed, e.g. tip cleaning.
Refer to cross references above.
Except in an emergency situation, switch the instrument off only after an
application is completed.
To switch the instrument off:
1 Press the power ON/OFF switch and keep it pressed for at least 2 seconds.
ATTENTION
Wait until the status light in the power switch is off (for approx. 10 sec.) before
switching the instrument on again.
Subject Reference
Empty/clean the waste container See section 7.3.7 “Liquid Containers”, 2 7-17
Subject Reference
Maintenance tasks See chapter 7 “Preventive Maintenance and
Repairs”, 2 7-1