22
In this page, users can set features like motion detection on/off, sensitivity, detection time, linkage alarm output, linkage output duration, E-mail sending after alarm has been triggered,
linkage device snapping/snapping, etc.
[Detection On/Off]: open or close motion detection.
[Sensitivity]: set the sensitivity of motion detection, its range is 1~5, greater value means higher sensitivity.
[Motion detection time setup]: set the period of motion detection. Any period in each day can be set up.
[Linkage alarm output]: When alarm is triggered, the built-in relays will be driven to output alarm.
[Alarm Output Duration]:
Set the duration of the linkage alarm output after being triggered (in seconds), the range of the duration is 0~86400s.0 means that there is no limit for alarm output.
[E-mail sending]: Send motion detection alarm information to users via E-mail, details about E-mail setting please refer to [Network Settings].
[Linkage Snapping]: Drive device snapping after alarm has been triggered, and save pictures to device HDD. For snapping parameters, if the number of pictures snapped at one time is set as 5, and the snapping
interval is 1 second, that means when there is an alarm, 5 pictures will be snapped and the interval between each picture is 1 second. The pictures snapped can be saved via E-mail sending or FTP uploading.
[Linkage Recording]: Drive device recording after alarm has been triggered, and save record files to device HDD. The record files can be saved via FTP uploading.
Note: Record packing duration= Alarm du duration set in linkage recording parameters.
[Set detective area]: left click and drive the mouse to set the surveillance areas (4 areas at most).
[All]: set the whole video as motion detection area.
[Clear]: clear all motion detection area.
After setting all the parameters, click [save] to make the parameters valid.
5.6.2 Video Loss Alarm
Below picture is the “Video Loss Alarm” page of INC-M20xx:
