sensitivity list box, press [ENTER] key to enter into “Motion Area Setup” interface.
The whole screen is divided into 22*18 panes (NTSC: 22*15). There is a pane of yellow on the up left corner. The motion area setup steps are the same as mask area
setup (refer to section 5.4.5). The differences are that you can use [PTZ] key to set the whole screen as motion detect area and multiple motion areas can be defined.
Setup multiple areas:
After finish setup one motion area, press [EDIT] key, the yellow pane will appear again, you can setup another motion area.
Clear part of motion area:
Move the yellow pane to a start pane then press [EDIT], you will find the yellow pane turn to black. Use [
È
] or [
Æ
] key to enlarge or
shrink the black area. Press [EDIT] key to clear this part motion area. Press [Enter] key to save settings and return to “Image Input Adjustment” menu. Press [ESC] to
cancel setup.
Clear all motion areas:
Press [A] key to clear all motion areas of this channel.
The following keys are used to setup motion areas:
•
[
Ç
] [
È
] [
Å
] [
Æ
] : Move yellow panel to any position
•
[EDIT] :Yellow panel and red panel switch key
•
[
Æ
] : Right enlarge red pane
•
[
Å
] : Left shrink red pane
•
[
È
] : Down enlarge red pane
•
[
Ç
] : Up shrink red pane
•
[PTZ] : Set whole screen as motion area
•
[A] : Clear all motion areas
•
[ENTER] : Save and return to “Image Input Adjustment” menu
•
[ESC] : Cancel setup and return to “Image Input Adjustment” menu
The motion detection areas show as following illustration.
Step 5: Motion alarm policy
Move highlight item to the “Policy” button on the right of “Motion Det. Level” item, press [ENTER] key to enter into “Motion Alarm Control” menu
Step 6: Motion alarm record channel setup
When motion alarm happens, it can trigger camera(s) linked to the sensor to start recording. Linked camera can be single camera or multiple cameras. In “Motion
Alarm Control” menu, use [ENTER] or [EDIT] key to enable the check box of target channel.
Note:
In order to make the camera starting record, in “Recording” menu, you must enable recording schedule and set “Rec Type” as “Motion Detection” or “Motion |
Alarm”. Please refer to section 5.5 for recording setup.
Step 7: Motion alarm schedule
____________________________________________________________________________________________________________________________________________________________
NetDVR User Manual
[
42
]