4000 Series Programmable Pushbutton Lock
19
Getting Started
The 4000 Series lock can now be programmed as desired. Start by programming
the Master authorization code to an eight-digit number other than the factory
default 12345678. See the last page of this manual where a “Code Record Log
Sheet for the 4000 Series Lock” is provided to record all authorization and
access codes for the lock. Store this document in a secure place. From this record,
the lock can be easily programmed with all the required codes.
4000 Series Programmable Pushbutton Lock
18
Getting Started
Chapter 5
Ensure that the 4000 Series lockset, the latch, and the strike plate are properly
installed. The signal cable inter-connecting the front and the back housing must
be correctly connected, and the four AA alkaline batteries (included) must be
inside the battery holder and conform to the marked polarities for the lock to
work.
The lock is delivered from the factory with one access code—the Service code
4000. (Note: If the examples on pages 17 and 18 were performed on the lock, this
code might have been deleted.) This access code can be used by the person who
installs the lock to test that the lock operates. When the access code is entered
using the keypad, the lock should unlock. After verifying several times that the
lock works properly, delete all access codes using the factory-default Master
authorization code 12345678:
#-1-2-3-4-5-6-7-8-#-3-0-0-#-#
The lock is now configured in the Commercial setup (factory default).
Note: If the examples on pages 17 and 18 were performed on the lock, ensure
that step 15 was performed to set the configuration to Commercial.
The following table compares the three available lock configurations:
The following parameters are identical for all three of the above setups:
Master authorization code
12345678
All 3 Manager authorization codes
blank or deleted
All 18 User access codes
blank or deleted
Service access code
blank or deleted
Passage mode
disabled
Hard-wired remote unlock
disabled
Commercial
Residential
Handicapped
Command code
800
801
802
Unlock time
5 seconds
5 seconds
20 seconds
Buzzer sound
loud
soft
loud
Tamper shutdown time
4 minutes
2 minutes
1 minute
