OP-131Tx_V2 User Manual.docx
Page
12
of
19
30-Aug-2018
© 2018 IKUSI ANZ Pty Ltd - All rights reserved - Reproduction without consent is prohibited
5.2 Set up the Hyper Terminal
If you have not setup the Hyper Terminal in your Windows system, follow the steps:
Click “start menu
→
program
→
accessory
→
communication
→
Hyper Terminal”:
This results in the following screen:
Then you input your connection name, such as “SNMP38400”
，
and choose the serial port to
connect with your equipment. As follows:
Press the “OK” button shows the configuration page of serial port. As follows:
Change the serial port configuration to 38400-baud rate, 8 data bits, no parity bit, 1 stop bit,
no data flow control, press the “OK” button, you have set up the Windows serial port Hyper
Terminal.
