18
Disconnect the machine from the power source and take
the following steps before restarting and operating the
machine:
• check for damage
• replace or repair damaged parts
• check for loose parts and tighten them
When working with this machine, do not use spare parts
other than those recommended by us. Using spare parts
not recommend by us can result in serious injuries to
persons or damage to the machine.
MAINS CONNECTION
DANGER!
Operation is only allowed with a safety switch against
stray current (RCD max. stray current of 30mA).
Before use check machine, cable, and plug for any dama-
ges or material fatigue. Repairs should only be carried out
by authorised Service Agents.
Insert the plug of the electrical cable in a socket of suitable
shape, voltage and frequency complying with current
regulations.
Keep the connection and extension cables away from
dangerous moving parts to avoid damaging them.
Only use splash proof extension cables approved for
outdoor purposes. The stranded wire cross-sectional area
of the extension cable must be at least 1.5 mm
2
for cables
up to 25 m and 2.5 mm
2
for cables above 25 m.
Only plug-in when machine is switched off .
The device is only intended for use on premises that have
a continuous current carrying capacity of >=100 A per
phase and are supplied from a electrical grid with a rated
voltage of 400/230V.
If necessary, please consult your electricity company to
ensure that the continuous current carrying capacity of
the mains at the connection point is suffi cient for connec-
ting the device.
WARNING
WARNING! Electric shock! There is a risk of an injury
caused by electric shock!
Do not use the device if the cable or plug is damaged or
worn.
If the cable is damaged during use, it must be discon-
nected from the mains supply immediately. Do not touch
the cable until it has been disconnected from the mains.
Do not connect a damaged cable to the power supply
and do not touch a damaged cable before disconnecting
it from the power supply, as damaged cables can lead to
contact with active parts.
SPECIFIED CONDITIONS OF USE
The scarifi er & raker may only be used for scarifying and
removing moss or for raking leaves, moss or weeds from
lawns in residential and hobby gardens – depending on
the attached roller.
The device may not be used in commercial applications.
WARNING
Risk of injury
Rotating blades may lead to serious injuries by cutting
or amputating parts of the body.
• Be careful to avoid injury by the cutting tools. Careful
appliance handling reduces the risk of injury by knife.
• Do not touch any dangerous moving parts before
the machine has been disconnected from the power
supply and the moving parts have come to a complete
standstill.
• All protection covers and safety devices must be correct-
ly attached to operate the device.
• Never use the machine with a damaged cover or protec-
tive device or without cover or protective devices.
Do not use this product in any other way as stated for
normal use. Not observing general regulations in force
and instructions from this manual does not make the
manufacturer liable for damages.
Please note that permissible uses for the tool could be
limited by national regulations. It is necessary to comply
with the regulations applicable in the country where the
device is used.
Do not use the device near fl ammable liquids or gases.
Risk of fi re and explosion in case of short circuit.
GB
ENGLISH
Summary of Contents for 80201020
