13
GB
|
Operating Instruction
Part
To do
Before/after
each use
10 hours
25 hours
50 hours /
half year
100 hours /
once a year
Spark plug
check
X
Spark plug
clean
X
Spark plug
replace
whenever necessary
Air filter
check
X
Air filter
clean
X
Air filter
replace
whenever necessary
Fuel filter
check
X
Fuel filter
clean
X
Fuel filter
replace
whenever necessary
4.1 Deck washing (optional)
(Fig. 25)
When the machine has stopped and is switched off:
- Connect the coupler (X) on the deck to the water-
supply tap.
- Turn on the tap.
- Switch on the engine (the blade should be spinning)
and let it run for a few minutes.
- When the machine is clean, switch off the engine. Turn
off the tap and remove the hose from the coupler.
Fig. 25
X
4.2 Change the blade
WARNING! Wear safety gloves when working
on the blade and close to it! Use proper tools
to remove debris, e. g. a wooden stick! Never
use your bare hands!
Always use original spare parts for replace-
ment. The replacement of the blade should
be done by a qualified specialist! Rework or
sharpening blades is not recommended un-
less it is done by a repair service or a simi-
larly qualified specialist!
NOTE: We strongly recommend jacking the
product up when performing inspection and
work on the cutting device. Avoid tilting the
product in order to prevent fuel and oil leak-
ages.
1. Keep the underbody and blade clean and free of de-
bris. Remove clippings from the discharge chute.
2. Check all nuts and bolts periodically for tightness
before operation. After prolonged use, especially in
sandy soil conditions, the blade will become worn and
lose some of the original shape. The cutting efficiency
will be reduced and the blade should be replaced.
3. Keep the blade sharp to ensure a good cutting per-
formance. Replace a worn or damaged blade with a
new one of the same type or have it sharpened by a
qualified specialist.
