43
Installing the blade guard
-
Install the blade guard (a) on the riving knife (b).
Riving knife information
-
Thickness 2,8
mm
-
Blade diameter
254 mm
-
Slot width
8,2 mm
Connection of dust collector
WARNING: Dust of certain timber species (e.g. beech, oak, ash) can cause cancer when in-
haled. Use a suitable dust collector when working in closed spaces.
The dust collector must meet the following requirements:
-
hoses must fit the outer diameter of the dust extraction ports (blade guard 30 mm and chip case
100 mm)
-
air flow volume
≥
460 m
3
/h
-
volume at dust extraction port of saw
≥
530 Pa
-
air speed at dust extraction port of saw
≥
20 m/s
Operation without a dust collector is only possible:
-
outdoors
-
for short-term operation (up to a maximum of 30 minutes)
-
with a dust respirator.
Mains connection
WARNING, DANGER OF ELECTRIC SHOCK!
-
Operate the saw in dry environment only.
-
Operate the saw only on a power source matching the following requirements:
•
mains voltage and system frequency conform to the voltage and frequency shown on the
name plate of the saw
•
outlet is properly installed, earthed and tested.
-
Position the power supply cable so it does not interfere with the work and is not damaged.
-
Protect the power supply cable from heat, aggressive liquids and sharp edges.
-
Do not pull on the power supply cable to unplug.
OPERATING ELEMENTS
On/Off-switch with emergency stop
-
To switch ON, press the green button.
-
To switch OFF, press the red button or switch cover.
Height handwheel for setting the cutting depth
The cutting depth can be adjusted by turning the handwheel. To adjust, first turn the height locking
lever down to loosen the height handwheel. After adjusting, turn the locking lever up to lock the
height handwheel.
a
b