9
STEP 3 - Opening the Housing
Lid Snaps have a
Lock
.
1. Push Lid Snap Locks forward and lift as shown.
Open opposing Lid Snaps simultaneously. Keep
pressure on the Lid Snaps so they do not fly
open quickly. Some Lid Snaps have a lot of
spring tension once they go over center, so keep
a firm grip on each Lid Snap. Lid Snaps may
also be opened one at a time.
2.
Remove the Housing Back.
Push Forward
Lid
Snap
Lock
Lift
1. Make sure the camera battery is fully charged and a SD card is inserted
into the camera.
2. Rotate Housing Lens Release Button control up and forward against
front of housing. Pull top housing control knobs up for more clearance.
3. The Mounting Plate is secured to the inside bottom of the housing. The
camera Mounting Tray slides into the Mounting Plate. Use your index
finger and thumb to pull the Thumb Screw and Tray away from the
Mounting Plate,
Diagram A, page 10
. Use your other thumb to apply
opposite pressure against the bottom of the housing to assist in removal
of the Tray if necessary.
STEP 4 - Install Camera/Hotshoe in Housing
when using a strobe/flash. When recording video or shooting stills
without a strobe, AWB can still be used, but for more accurate and
consistent colors we recommend setting Custom white balance .
*
All other camera functions not mentioned should be set to the user’s
preference.
STEP 2 - Initial Camera Settings -
continued