The factory installed flash Deflector should be
removed when using ONLY the built-in camera
flash and no external strobes. Pull the
Deflector away from the inside of the housing
front to remove. To install, line up the
corresponding Velcro dots on the housing front
and press the Deflector back into its factory installed position next to the
lens port. When properly installed, the Fiber Optic Holes should line up
with the housing Fiber Optic Ports, page 5.
Deflector Removal/Installation
Deflector
Velcro
Fiber
Optic
Holes
Diffuser Purpose
When shooting close-up photographs, the lens port on the housing can
block a portion of the light from the built-in camera flash. This can result
in a shadow in a lower corner of the picture frame. The Diffuser will help
eliminate the shadow. In addition, you can zoom in if necessary.
Diffuser
Small hole
Cut-out
Section
The included Diffuser should only be used when
shooting with the built-in camera flash. Always
remove the Deflector
before
using the built-in
camera flash and Diffuser.
To install the diffuser, push the “Cut-out” Section
into the port groove until it stops as shown. To
remove, grab the top of the Diffuser and pull
away from the port.
Note the Small Hole. To avoid losing the diffuser,
you can attach a fishing line or string to this hole.
Diffuser Installation/Removal
Diffuser properly
installed in port groove
10
