Closing the Housing
1. Place housing face down in your lap.
2. Check to see that there is an o-ring on the housing back that is clean
and in its proper location.
3. Guide the back onto the housing. The o-ring should touch the housing
all the way around. There should be an even gap all the way around
between the housing and the housing back.
4. Lift the lid snaps so they are extended
and place the lid snap into the
corresponding hook on the housing back.
5. To close the housing, push down on the
lid snaps until they snap into place. Lid
snaps on opposite sides of the housing
should be closed at the same time. Be
sure they are down far enough to engage
the lid-snap lock.
Using the Built-in Camera Flash
DO NOT
extend the camera flash before placing camera in housing.
If you are shooting with the built-in camera flash, remove the factory
installed Deflector and install the Diffuser (included), see page 10. The
camera’s built-in flash CANNOT be used with optional Wide-Angle or
Accessory lenses.
For the best results, we recommend using an external Ikelite Strobe with
the removable housing Deflector installed.
8
housing back
housing
o-ring
even gap
all 4 sides
