v
Precautions Upon Use
In order to use the monitor safely, read through this
manual and pay attention to the following points in
particular.
1. Do not use any power supply other than the specified
one (AC/DC).
2. Do not give a shock to the monitor.
Be very careful to keep the monitor from shocks because
glass is used inside the LCD.
3. Do not use or store the monitor in the following places.
Place where the ambient temperature is out of spec
When installing the monitor on a monitor shelf, switcher
table, rack, etc., make sure in advance that the
temperature of the installation location is within the
specified range.
In the case of an outdoor setup, even if the ambient
temperature is within the specified range, the inside of
the monitor may be heated by direct sunlight. Therefore,
keep radiation in mind. (Avoid direct sunlight.)
Never block the air outlet at the rear of the monitor and
the air inlet at the side. Make sure in particular that a
blackout curtain or the like does not block the air outlet.
Place exposed to rain, snow or high humidity
Use of the monitor in such a place will cause electric
leakage or failure.
4. Avoid exposing the LCD screen to direct sunlight.
Exposure of the LCD screen to direct sunlight for a long
time will degrade the film. Therefore be careful of direct
sunlight when using the monitor outdoors.
5. Cautions in handling the front LCD panel
Be careful not to touch the LCD panel front surface with
bare hands, unless necessary. When wiping the dust off
the surface, use soft, dry cloth and take care not to rub
the surface strongly. Do not use thinner or benzene.
6. Do not touch liquid crystal leaked from the monitor's
display surface.
If the monitor's display surface is accidentally broken
and the liquid crystal leaks, be careful never to put the
liquid in your mouth, inhale it and allow it on your skin.
If the liquid gets into your eye or mouth, immediately
rinse it with water and get medical attention.
If the liquid contacts your skin or clothes, immediately
wipe it off using alcohol or the like and wash the stained
spot with soap and water. Do not leave the liquid intact,
because otherwise your skin or clothes may be affected.
7. Do not display the same pattern for a long time.
Note that residual image may be generated if the same
pattern is displayed for a long time.
Turn off the power when the monitor is not used.
To avoid residual images, preferably take the following
measures.
Change the screen regularly.
Display the whole screen in white.
8. Caution for condensing.
When the monitor is used in the condition where
temperature abruptly changes, the surface of LCD panel
and the inside of monitor are possible to get condensed.
And if it is used leaving condensed, it can cause
deterioration of quality and trouble.
If the device is condensed, please do not turn on the
power until waterdrop is disappeared completely.
9. Avoid operation or storage in a place exposed to
corrosive gas.
Operation or storage in a place where any corrosive gas
such as sulfur dioxide, hydrogen sulfide, chlorine or
ammonia is generated may lead to a significant
reduction in the monitor service life. It may also cause
failure or electric leakage.
Also avoid using the monitor in a location exposed to
high salty wind.
10. Do not use this monitor for such applications as space
appliance, nuclear control system as any medical
equipment involving human life.
