- -
19
C/T(Screen top center displayed)
C/B(Screen bottom center displayed)
R/T(Screen top right displayed)
R/C(Screen center right displayed)
R/B(Screen bottom right displayed)
In the 480i/575i/720p format, the image appears
at the center of the screen regardless of this set-
ting.
This function can be assigned with the
F1
F2
switch on the front panel.
Default setting is CENTER.
Ԡ
Setting the SDI channel switching lock ON/OFF
The lock is set to "ON" to prevent SDI signal
channel switching.
It utilizes the MONITOR OUT terminal and is
effective in fixing the channel. It prevents acci-
dental channel switching.
Default setting is OFF.
̪
Before setting it to "ON", make sure the desired
SDI channel is selected.
㩷
ԡ
Setting the format display ON/OFF before
switching signals
Used to set whether the channel and signal format
are displayed or not.
3SEC ON
㧦
Three seconds indication
CONT ON
㧦
Consecutive indication
OFF
㧦
Indication off
Default setting is 3SEC ON.
㩷
Ԣ
Setting the type of battery
This function is used to set the voltage (discharge
ending voltage) for warning that the battery is low.
Select an appropriate mode according to the
nominal voltage of the battery to be used.
AC/Ext.
㧦
AC or external stabilized DC power
supply
DC+14.8V
㧦
Battery with nominal voltage of
14.8V or 14.4V
DC+13.2V
㧦
Battery with nominal voltage of
13.2V
DC+12.0V
㧦
Battery with nominal voltage of
12.0V
Default setting is AC/Ext.
1) For the nominal voltage of the battery, refer to the
indication on the battery or the instructions
manual of the battery.
2) For the following batteries, select DC +14.8V in
the battery mode setting.
endura 7,7S by IDX CO., Ltd.
endura 10,10S by IDX Co., Ltd.
3) When using the battery equipped with XLR 4-pin
connector or when operating the battery using
XLR 4-pin connector, make a proper selection in
the battery setting according to the nominal
voltage of the battery used.
Example: HP-90L by Paco Electronics Industry,
Inc. : DC+13.2V
㩷
4) When operated with the setting not in accordance
with the battery’s nominal voltage, the following
events may result.
㩷
ŏ
When nominal 13.2V battery is used with
+DC12V setting.
Battery alarm, 30-second alarm and shutdown
alarm will function. However, it may take longer
from activation of the battery alarm until shut-
down.
Also, the battery life may be adversely affected
as the voltage is lower than the discharge ending
voltage.
㩷
ŏ
When nominal 13.2V battery is used with
+DC14.8V setting.
Service hours are shortened.
㩷
ŏ
When nominal 12.0V battery is used with
+DC14.8V setting.
Battery alarm and 30-second alarm may be
triggered shortly even if fully charged battery is
used, shutting down the monitor.
㩷
5) If operation is stopped shortly despite correct
battery mode setting (shutdown alarm will not
flicker), it is likely that the battery’s internal
protection circuit has been activated.
㩷
Precautions for battery
46
.6
.$
.%
%6
%'06'4
4%
4$
%$
