Iiyama ProLite XU2292HS, User Manual

Page: 18 / 45

ENGLISH
14 BEFORE YOU OPERATE THE MONITOR
CONNECTING YOUR MONITOR : ProLite XU2294HS / ProLite XU2292HS
Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the monitor to the audio equipment with the Audio Cable for computer when using the
audio features.
Connect the Power Cable to the monitor first and then to the power source.
Turn on your monitor and computer.
[Example of Connection]
<Back>
NOTE

The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama office.

For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.

Make sure you tighten the finger screws at each end of the signal cable.

The Class I pluggable equipment Type A must be connected to protective earth.

The socket-outlet shall be installed near the equipment and shall be easily accessible.

Excessive sound pressure from ear-/headphones can cause hearing damage/hearing loss.
* VGA cable is not supplied with the monitor. If you use low quality VGA cable, it may cause a result
of electro-magnetic interference. Please contact the iiyama Support Centre in your country if you
wish to connect the monitor via the VGA input.
[ Collect Cables ]
Put the cables through the cable holder to bundle
them.
AV Equipment etc.
Audio Cable (Not included)
Computer
VGA Cable (Not included)*
DisplayPort Cable (Not included)
HDMI Cable (Accessory)
Power Cable (Accessory)