-44-
7.5.10 FAN Alarm Release Function and Lamp ON Operation
Conditions:
Attach the Air Filter and disconnect the AC power cord. Plug the AC power cord
again and press the <ON/STANDBY> key.
Requirements:
•
The POWER LED light up green and the lamp is turned on.
The Fans rotate.
•
The Lamp LED blinks green and goes on green after three second.
Measurement:
Key Panel
Fan
7.5.11 Drop Impact Test
Conditions:
In the VIDEO and PC mode, lift the LPX100 projector about 5 cm and drop it with
the front/rear side down three times.
Input: VIDEO and PC
Requirements:
•
The SOURCE key allows selection between the VIDEO mode and the PC mode.
•
In the VIDEO and PC mode, there is no image disturbance including noise on the
image.
•
The LED does not flash even momentarily.
•
The Lamp does not go out.
Measurement:
Projected image
PC-OUT image
Key Panel
Adjustment Procedures:
When the Lamp goes out, replace the Lamp.
7.5.12 Tilt Foot Function
Conditions:
Move Tilt Foots up and down.
Requirements:
•
Tilt Foots rotate smoothly.
•
The LPX100 projector does not rattle.
Measurement:
Tilt Foots
