-26-
REVCLDLY Adjustment
Select a crosshatch pattern (for R/G/B).
Equate the widths of the vertical lines and
horizontal lines.
Select the adjustment value among the values of
+/- 20 or more from the point where there is jitter
in the vertical lines.
Verify that there is no jitter on the vertical lines in
each of RGB colors and the vertical lines are not
tinted in the all white crosshatch pattern.
Select a gray-scale pattern (for R/G/B).
Adjust each color to minimize the faint vertical
stripes.
CK-PHASE Adjustment
Select a gray-scale pattern (for R/G/B).
Adjust each color to minimize the vertical
stripes.
NRS Adjustment
Select a gray-scale pattern (for R/G/B).
Adjust each color to minimize the vertical stripes.
VIDR Adjustment
Select an OPTION 2 pattern of G in one color.
Adjust G-OFFSET so that the intensity difference
between 0% and 5%, 95% and 100% can be
distinguished.
Select a gray-scale pattern.
Adjust White Balance to be optimal value.
GHOST Adjustment
Select an OPTION 2 pattern.
Adjust each color to minimize ghosts.
REVGHOST Adjustment
Select an OPTION “2 pattern.
Adjust each color to minimize ghosts.
Adjustment Value Storage
Exit the Test mode with
EXIT
and save
Adjustment Values.
Plug Play data writing
VG-828 DVI digital serial output.
*Make this adjustment only when
Connect (EX OUT CH1) to the PC input of the LPX100.
data is written into the EEPROM.
LPX100 is in the Standby mode.
Start up VG Data Editor and send data.
Receive and check data.
Interlock SW Operation Check
Disconnect the AC power cord.
Remove the Lamp Cover Assembly installed
in the Bottom Cover Assembly and plug the
AC power cord.
End of Adjustment
Verify that the power is not turned on. Then
install the Lamp Cover Assembly and verify
that the power is turned on.
(Continued)
