7
Firstly, remove the protective film from the BoB2™ handset display screen.
Powering up
Please only use rechargeable batteries in your BoB2™ handset. Using non-rechargeable batteries could pose
health risks and cause damage to the handset.
To open the battery cover, apply slight pressure and then slide the cover towards the base of the handset.
1.
Insert the batteries as indicated by the symbols in the battery compartment.
2.
To close the battery cover, align the two clips with the grooves then slide the cover upwards.
3.
You will hear a click as the cover locks into place.
4.
If the handset does not power on, press and hold the red end call key.
The first battery charge and discharge
To keep your BoB2™ handset in top notch condition, follow the steps below for the first battery charge and
discharge.
1.
Plug the charging cradle into an electrical outlet using the supplied power adapter.
2.
Place your BoB2™ handset in the charger for six hours or until the battery is completely full.
3.
Then remove the handset and allow the battery to discharge to the point where it will no longer turn on.
4.
You can now fully charge the handset again and use it as normal. Please note, you will need to repeat the
above process if you replace the batteries.
Getting started with your BoB2™ handset
Summary of Contents for BOB2
Page 1: ...Handset Manual Internet and Phone in One ...
Page 2: ......
Page 30: ...30 ...
Page 31: ...31 All Done ...
