-7-
www.igmtools.com
the panel (see below). The cover can be
made from wood or plastic.
First, push down the emergency stop. Then lock
the cover together by putting padlocks [not
included] on the two handles on the control
panel. To safeguard your machine from
unauthorized operation and accidental starting
by young children, the use of padlocks is strongly
recommended
Pic. 11
Pic. 12
6.
Assembly and Set Up
6.1 Assembling the rubber feet
Method 1
Fit the rubber feet to the bandsaw prior to
removing it from the packaging.
Method 2
1. Support the bandsaw on wooden blocks.
2. Assemble the rubber feet with the fixings
provide both at front and back of the bandsaw.
Pic. 13
Pic. 18
Pic. 19
The table has a reference stop bolt that is used
to quickly align the table after tilting. The stop
bolt hits the tilt-blanking disc when it is
positioned over the table tilt hole. When the tilt
blanking disc is moved away from the hole, it
allows the tilt stop bolt to pass through the table
tilt hole, and the table can be moved to the
maximum amount of tilt (-7 degrees).
Table mounted to the bandsaw
Pic. 20
Pic. 21
Pic. 22
6.2 Assembling the optional mobility kit
Pic. 14
1. Support the bandsaw on wooden blocks.
2. Fit the swivel assembly to the back of the
bandsaw with the provided bolts.
3. Fit the front wheels to the front of the
bandsaw with the bolts provided and remove
the two rubber feet that are close to the front
wheels.
Note
. Never operate the bandsaw with the
mobility kit engaged or the front wheel
assembly locking screw not engaged.
Pic. 15
6.3 Fitting the table
Pic. 16
Pic. 17
It is possible to fit the table to the bandsaw with
one person but far easier if you have two
people, one to lift the table and one to guide the
trunion clamp studs.
Wooden safety cover
Padlock
Emergency stop switch
Plastic safety cover
Padlock
Rubber feet
Bandsaw supported on wooden block
Rear swivel wheel
Front wheels
Locking screw
Trunion clamp stud
Tilt stop bolt
Tilt stop bolt
Tilt blanking disc
Tilt blanking disc
Table tilt hole
Trunion clamp stud
Ratchet handle
