-10-
www.igmtools.com
Step 32. Attach the handles to the top and bottom end on the front panel
with the window display using (4) flat head Philip bolt, (4) 5/16” x 7/8” flat
washers and (4) 5/16” hex nuts. Note that the head of the Philip bolt must
be inserted from the handle with the hex nut and washer on the inside of
the drum.
Step 33. Take the Octagon drum front and back panels and assemble
together by securing with (12) M4 x 12mm sheet metal screws.
Step 34. One the left and right side you will find three bolt holes. Take the
matching side plate and secure to the outside of the panel using (6) 1/4” x
1/2” carriage bolts, (6) 1/4” x 1” flat washers and (6) 1/4” hex nuts. Insert
the head of the carriage bolt from the inside of the drum with the washers
and nuts on the outside of the drum.
Step 35. Lay the drum on its side with the handle facing top. With the help
of another person, hold the base panel with wheels up against the base of
the drum. Using (22) M3 x 6mm Truss head Philips flat point screws and
M3 cap nuts secure and fasten tightly. Make sure the head of the truss
head Philip screw is on the inside of the drum. The cap nut is secured
from the outside. Otherwise this will cause for air leakage regardless of
silicone being applied.
Step 36. Once completing the assembly, keep the drum laying on its
side to apply silicone (not included) to the inside of the drum, including
the base and the top rim of the drum before the rubber seal has been
attached to seal and prevent air leakages. You will need to use a caulking
gun (not supplied)
Step 37. Attach the rubber gasket to the top inner edges of the Octagon
drum. The wider end of the gasket goes up. Use tin snips to trim any
excess rubber gasket after completing the seal.
Step 38. Insert the plastic debris collection bag inside the Octagon drum.
Open and spread out the plastic bag to the corners and edges.
Step 39. Use (24) Round hd Philip bolts 3/16”*1/2” and (24) Cap nut 3/16”
to assemble the drum insert together. Place the drum insert inside over
the plastic bag in the Octagon drum.
Step 40. Lift the foot peddle bar. Align the Octagon drum window to the
center point of the drum lid and push the drum in. Lower the foot peddle
bar to seal the drum tight for normal machine operation.
Step 41. Make sure when aligning the drum that both the left and right
side lift plates are over the topping on the foot peddle bar assembly before
lifting the foot peddle bar up. When not aligned, the drum will not be fully
sealed and will interfere with the air flow.
