-5-
www.igmtools.com
4.3 Contents
Edgebander Support
table Corner guide End
trimmer
Light transport bag
Sample tape from calibration procedures
5. 5. TRANSPORT, UNPACKING AND ASSEMBLY
5.1 Transport and unpacking
The machine is not assembled due to transport.
Assemble before operating. Remove the edgebander
from the packaging and place on a flat surface. Check
for any apparent transport damages, these could
damage the machine or your health.
5.2 Assembly
5.2.1 Mounting the corner guide
- Equip the corner guide only when banding inner
corners or a radius smaller than 50 mm. It would be
getting in your way during other operations.
- Place the corner guide on your edgebander
according to pic.5 and tighten the screw.
6. SET-UP AND ADJUSTMENT
6.1 Preparing for work
6.1.1 How to measure and set up tape width
- Loosen the screw on the tape stop (pic.6)
- Place the tape under the stop and measure the
height (pic.7), tighten the screw.
- Measure the thickness of the banded piece and set
up the support table accordingly, make sure to tighten
the locking lever properly (pic.8)
Fig
7
pic.5
Fig1
pic.6
Fig3
333
pic.8
Fig2
pic.7
Operating instructions EN
