-6-
www.igmtools.com
6.1.3 Adjusting the amount of applied glue The
amount of glue is pre-set and should suit the majority
of operations.
- If the amount of glue is not convenient. Prepare a test
tape, warp up your machine and load the tape. Use the
amount of glue adjustment knob to set the demanded
quantity. Turning left adds and turning right decreases
the amount of applied glue (pic.6) The scale displays the
amount of glue.
- Caution: Do not turn the adjustment knob until the
glue has reached operating temperature.
- Too much glue overflows on the visible side of the tape.
Not enough glue is not evenly applied along the whole
width of the tape.
6.1.4 Thickness of tape
Set up thickness only when you have a softer or
thinner tape than 1 mm. Otherwise, the pressure
automatically ajdusts to the tape. The thickness can be
simply set by a turn of the knob (pic.11).
pic.9a
pic.9b
2
pic.9c
6.1.5 Setting up tape length
- Measure the length of the banded edge and leave a
bit more of the tape for final trimming.
- Apply enough pressure when trimming the edge, this
will improve the finish.
10
accordingly by loosen the handle and tight the handle after setting the width on guiding
plate.
2.
Guiding place adjustment
The surface of the guiding plate must be perpendicular to the pressure roller. Loosen
screw (1) and place guiding place onto the workpiece. When the workpiece is
perpendicular to the pressure roller, tighten the screw (1). Loosen the screw (3), adjust
the plate to “0” (4) then tighten screw (3) again.
3.
Glue Adjustment
When machine reach working temperature, prepare a testing edge band (approx. 20cm/
8”) and insert with lowest feeding speed and micro-adjust glue knob to desired
application. (Fig 4)
※
Caution: Do not turn the glue knob when the machine has not reached its working
temperature.
4.
Thickness adjustment
：
Adjust thickness adjustment knob and screw accordingly when
feeding soft or thin edge band. (Fig 5)
Fig1
Fig2
Fig3
Fig 4
Fig 5
pic.10
10
accordingly by loosen the handle and tight the handle after setting the width on guiding
plate.
2.
Guiding place adjustment
The surface of the guiding plate must be perpendicular to the pressure roller. Loosen
screw (1) and place guiding place onto the workpiece. When the workpiece is
perpendicular to the pressure roller, tighten the screw (1). Loosen the screw (3), adjust
the plate to “0” (4) then tighten screw (3) again.
3.
Glue Adjustment
When machine reach working temperature, prepare a testing edge band (approx. 20cm/
8”) and insert with lowest feeding speed and micro-adjust glue knob to desired
application. (Fig 4)
※
Caution: Do not turn the glue knob when the machine has not reached its working
temperature.
4.
Thickness adjustment
：
Adjust thickness adjustment knob and screw accordingly when
feeding soft or thin edge band. (Fig 5)
Fig1
Fig2
Fig3
Fig 4
Fig 5
pic.11
6.1.2 Control and gauge set up of the support table
- The
pre-set
support table is perpendicular to the
pressure plate. Place the support table on a mitre gauge
(pic.2, gauge not supplied) to check proper allignment. If
the table is not perpendicular, loosen the screw (1). Align
the table according to the mitre gauge, tighten screw
(1). Release screw (3) and set up the gauge (4) to „0“, then
tighten again.
Operating instructions EN
