en
11
User Manual Santiago Bemar
www.igloo.pl
1- Ceramic infrared radiators 250W/230V
2- Bulb screen
3- 40W bulb (E27; P45 bulb shape; max working
temperature of up to 300ºC)
Fig.9 Bain-marie lamp system
1 -
Alarm level
sensor – very low level of
fl
uid in the tank (red diode signal), when
fl
uid level falls below this sensor sound alarm
is activated and heating function is simultaneously inactivated
2 -
Optimum
fl
uid level
sensor (green diode shall illuminate when
fl
uid falls below this level)
3 –
Minimum
fl
uid level
sensor (red diode is illuminated)
4 – Water temperature sensor
5 – Tank water outlet hole
4.2. Temperature regulation
Bain-marie is equipped with mechanical temperature regulator. Temperature sensor is located in the bain-marie tank
Fig.7/4 (p.11). We set the desired water temperature in the tank Fig.6/6 (p.10) with the help of regulating knob by
turning it and setting in proper position. Turning the knob clockwise increases the set temperature, and turning it in the
opposite direction causes the decrease of temperature. Turning the knob left; until it reaches the
fi
nal position turns
off the heaters, despite the fact that the power supply is activated.
4.3. Lamp system
The lamp system includes ceramic infrared radiators and bulbs aimed to operate in high temperatures.
Infrared radiators are used for additional, super
fi
cial dish heating. They use the phenomenon of temperature radia-
tion, aiming in absorbing and changing the radiation energy falling on heated dishes into heat. Radiated waves fall
through air without any dif
fi
culties and do not emit heat until they reach the heated surface.
Bulbs and infrared radiators may be turned on/ turned off independently with switches placed on control panel Fig.6/2;
3 (p.10).
Fig.8 Bain-marie tank
4
1 2 3
5
1
3
2
2
When bain-marie tank is properly
fi
lled with water, control panel diodes should not be illuminated at all.
5. MAINTENANCE
5.1. Cleaning and maintenance
All maintenance services need to be performed after disconnecting the device from power supply!
Protect electric installation against any damage or water spillage
Do not use water stream to clean the device, only a wet cloth
Do not use any sharp objects to remove dirt!
Devices with wheels cannot be used on uneven surfaces!
