43
TOC-750 Module PCB Setup Functions From the 750 Controller. General
Pellistor Settings and module options
With 345 entered as a password the software will prompt for the
Highway Cable (e.g: 1 to 4)
to
be checked and which cable port it is connected to. The software then displays the following
setup page.
Note that the opening screen will show the setup options for the pellistor input as this is always
the first physical channel. The setup options listed below the ‘pellistor settings’ button may not be
displayed if the pellistor option is listed as ‘disabled’ on the basic setup display on the right.
The display of the ‘module’ PCB shows six option buttons. Pressing the button will allow you to
cycle through each of the available setup options for that feature. depending what is selected will
determine what is then displayed for each option on the left.
The picture below shows the opening screen for the module PCB setup. The module PCB shown
graphically on the right indicates the six functions available and their current setup status. This
can be altered at any time by cycling the relevant button. Each of the six functions then has setup
options. These are indicated sequentially on the right as each function button is selected. The
screen below shows the availabe pellistor settings.
Pellistor Setup Options Are
Only Displayed if the Module
Selection is MK3, MK6, MK7. If
the Option is Selected to
Indicate ‘Disabled’ Then These
Options Are Note Displayed
Setup Options
Function Selection Buttons
Options available for the Pellistor Input allow:
Change of Unit Address, Change of Range (Normally 0-100% LEL),
Change of Gas Type (Typically CH4, LPG etc), Change of Units (Typically %LEL),
Add a Tag Line to the Pellistor, to describe location etc
