IGBT D
IMMER
R
ACKS
Installation
& Operation
53
N
OTICE
T
O
C
ONTRACTOR
DO OT
No part of this system may be energized or operated until the installation has been approved by a Philips Controls Representative.
Violation of this Requirement may damage components and therefore constitute misuse under standard warranty terms. Such misuse
may relieve Genlyte Controls of any and all further obligations under the terms of this warranty.
Equipment must be installed per the "AS BUILT" drawings. These drawings reflect changes in the equipment based on the returned
Approval submittal drawings and/or any changes that may have occurred in production. Previous sets of drawings should be destroyed.
All
installation and wire terminations MUST be completed per the "AS BUILT" drawings and prior to the arrival of the Field Service
Representative:
1) Input power must be connected to the system, but not energized.
2) All loads must be connected and all lighting instruments must be lamped.
3) All control wiring must be installed and terminated - including DMX512, Ethernet and Lytemode® ILS.
4) All equipment, including controllers, accessories, keys, cables and manuals must be in place.
5) Personnel for training (i.e. the users), as well as any other personnel required by contract and/or specification must be available for
training at the completion of the Engineering Checkout and Energization.
6) An owner (or authorized representative), as well as any other personnel required by contract and/or specification will be present to
accept the system.
The Field Service Representative will only be able to:
•
Ensure that the system is properly installed and functions correctly, including troubleshooting and providing guidance to the contrac-
tor to correct any problems.
•
Train personnel in the operation of the Lighting Control System.
The Field Service Representative will not
be able to:
• Install equipment or make electrical connections required of the installing contractor, including DMX512, Ethernet, Lytemode
ILS, and/or any other connections that require a licensed electrician.
• Return to instruct any personnel who missed the original training session.
The Field Service Representative will be required to leave the job site if the above requirements have not been met. Any return
trips to
complete the Engineering Checkout will be at a cost of travel plus per diem, was well as a labor rate of $80 per hour travel time door-
to-door and $800 per day on site. Rescheduling will require 3 weeks notice.
Please feel free to contact Philips Controls Technical Services (+1-800-526-2731) should there be any questions regarding the installa-
tion of the equipment or requirements regarding the Engineering Check-Out.
Refer to the following page for the
Engineering Check-Out Request Form
.
