9
ZZ1102 I/O module
UK
1
3
C F PWR/CAN
2
Mounting the cover:
► Pull out the locking lever (1) and rotate it
towards you�
►
Place the cover diagonally onto the
BasicController (2). To do this, insert the two
guide brackets (3) into the slots provided in
the BasicController�
►
Press the cover on�
► Move the locking lever (1) back into its initial
position�
C: Inputs
F: Outputs
► Connect the M12 connector of the CAN/power adapter cable to the O3M 3D sensor (→ 7.1).
►
Connect the two twisted wires of the CAN/power adapter cable to a power supply: Blue: GND, brown:
L+ (24 V).
►
Assign the lines to the inputs and outputs of the BasicController as required� Take pre-programming
into account → 7.2, Table 1.
