ZZ1102 I/O module
6
7.1 Wiring of the O3M 3D sensor
1
①
Power supply and CAN bus
4
2
1
3
5
1 Shield
2
24 V
3 GND
4 CAN High
5
CAN Low
Fig� 4: Wiring of the O3M 3D sensor, back
7.2 Wiring of the BasicController
The supply cables, CAN interfaces and input/outputs are connected via 6�3 x 0�8 mm blade male terminals on
the front of the BasicController�
Block C (inputs) and Block F (outputs) are pre-programmed.
► Connect the BasicController via these terminal strips (→ 7.2.1).
The BasicController features an application-specific configuration� The configuration is also used as
part of application packages (e.g. O3M Area Surveilliance ZZ1103).
N2
2
3
1
A
B
C
D
E
F
N2
P/N1
①
Inputs (A, B, C)
②
Outputs (D, E, F)
③
Supply and CAN interfaces
Fig� 5: Wiring of the BasicController
