23
UK
10.4.4 Define colour of the display
►
Select [coLr] and define the colour of the process value display:
rEd (display always red), GrEn (display always green)�
Menu DIS:
[coLr]
10.4.5 Set the measured value damping
►
Select [dAP] and set the damping constant in seconds
(Ƭ value 63 %): 0...5 s (→ 4.6)
�
Menu CFG:
[dAP]
10.4.6 Set output status in fault condition
►
Select [FOU1] or [FOU2] and set the value:
-On = The analogue signal goes to the upper fault value
�
-OFF = The analogue value goes to the lower fault value
-OU = The analogue signal corresponds to the measured value�
Menu CFG:
[FOU1]
[FOU2]
10.4.7 Calibrate curve of measured values
►
Select [CGA] and set a percentage between 60 and 140
100 % = factory setting�
[CGA] is only available if the operating mode GAS or LIQU is
selected�
Menu INI:
[CGA]