O3R222 O3R225 O3R252
2D/3D camera head
4
2 Safety instructions
•
The unit described is a subcomponent for integration into a system.
– The system architect is responsible for the safety of the system.
– The system architect undertakes to perform a risk assessment and to create documentation in
accordance with legal and normative requirements to be provided to the operator and user of
the system. This documentation must contain all necessary information and safety instructions
for the operator, the user and, if applicable, for any service personnel authorised by the
architect of the system.
•
Read this document before setting up the product and keep it during the entire service life.
•
The product must be suitable for the corresponding applications and environmental conditions
without any restrictions.
•
Only use the product for its intended purpose (
Ò
Intended use).
•
If the operating instructions or the technical data are not adhered to, personal injury and/or damage
to property may occur.
•
The manufacturer assumes no liability or warranty for any consequences caused by tampering with
the product or incorrect use by the operator.
•
Installation, electrical connection, set-up, operation and maintenance of the product must be
carried out by qualified personnel authorised by the machine operator.
•
Protect units and cables against damage.
2.1 Safety symbols on the unit
The following symbols are used on the device. Observe the subsequent sections in order to avoid
hazards:
Electric supply must correspond to IEC 61010-1, chapter 9.4 - Limited-energy circuit.
Laser safety.
Device of protection class III. Only for operation in PELV circuits.
2.2 Laser safety
LASER
1
Marking on the device:
CLASS 1 LASER PRODUCT
IEC 60825-1:2014
21 CFR PART 1040
The device emits invisible laser radiation (λ=940 nm ±5 nm) of laser class 1 according to
•
IEC 60825-1:2014 and
•
EN 60825-1:2014.
USA
Complies with 21 CFR 1040.10 except for conformance with IEC 60825-1 Ed. 3, as described in Laser
Notice No. 56, dated May 8, 2019.