46
ifm
Programming Manual BasicController relay CR0431 v03.03.00
05 / 2018
Configurations
Function configuration of the inputs and outputs
>
Binäry inputs: configuration and diagnosis
19689
Configuration of each input is made via the application program:
• FB
INPUT
(
) > input MODE
MODE
BYTE
operating mode of the input channel:
0 = 0x00
off
3 = 0x03
voltage input
0…10 000 mV
6 = 0x06
voltage input, ratiometric
0...1 000 ‰
7 = 0x07
current input
0…20 000 µA
9 = 0x09
voltage input
0…32 000 mV
10 = 0x0A (only for analogue evaluated inputs)
binary input, plus switching (BL)
11 = 0x0B
(only for analogue evaluated inputs)
binary input, plus switching (BL) with diagnosis
(Namur)
12 = 0x0C binary input, minus switching (BH)
18 = 0x12 resistance input
16...30 000 Ω
>
Activation of the input diagnosis
7352
If the diagnosis is to be used, it needs to be activated additionally.
► Set the mode of the input via input MODE of the function block
INPUT
(
>
The FB
INPUT
(
) provides the diagnostic messages of the inputs on its RESULT output.
NAMUR diagnosis for binary signals of
non-electronic switches:
► Equip the switch with an additional resistor
connection!
Figure: non-electronic switch S at input Inn
Sensors with diagnostic capabilities to NAMUR can be used on these inputs.
In this case, no additional resistor connection is required.
Summary of Contents for ioControl CR2050
Page 228: ...228 10 Notizen Notes Notes ...