![background image](http://html1.mh-extra.com/html/ifm/dd111s/dd111s_original-installation-instructions_3904538020.webp)
20
7.2 Setting the switch point
Step 1:
► Switch off power supply of the device�
► Set the 3 switches to configuration position P or P/0 (→ 7.1)
► Switch on power supply of the device�
> Device is in the configuration mode�
> LED [CONF] flashes�
Step 2:
► Set switch S1 from the position P/0 to the required value�
> During the rotation, the LED [ENA] flashes with every step�
The flashing of the LED is a visual feedback of each step executed�
> Device remains in the configuration mode and waits for S2 to be set�
> LED [CONF] is still flashing�
Step 3:
► Set switch S2 from the position P/0 to the required value�
> During the rotation, the LED [ENA] flashes with every step�
The flashing of the LED is a visual feedback of each step executed�
> Device remains in the configuration mode and waits for S3 to be set�
> LED [CONF] is still flashing�
Step 4:
► Set switch S3 from the position P (DD110S) or P/0 (DD111S) to the required
value�
> During the rotation, the LED [ENA] flashes with every step�
The flashing of the LED is a visual feedback of each step executed�
> LED [CONF] remains permanently on�
Step 5:
► Wait until LED [CONF] flashes twice (settings are saved)�
► Switch off power supply of the device�
> Configuration is completed�
To ensure that a value can be set all 3 switches have to be moved at least
once� This also applies if the required value is "0" (corresponds to the "P"
position)�