IFM DD111S, Original Installation Instructions

Page: 12 / 27

12
Plug Terminal Connection
A2 L- Supply voltage (GND)
directly connected to the device ground
S44 Sensor 2 supply (+ 24 V DC)
S45 Sensor 2 GND (0 V DC)
S43 Sensor 2 input
A3 13 Current path 1A (relay contacts)
(not connected)
(not connected)
14 Current path 1B (relay contacts)
C1 Y3 Deactivation of the monitoring function (P) (→ 5.3)
Y4 Deactivation of the monitoring function (N) (→ 5.3)
Y5 Automatic mode selection
Y6 Manual mode selection
C2 Y7 Transistor output "Fault" (→ 3.6)
Y8 Transistor output "Overspeed" (→ 3.7)
Y1 Feedback circuit output
Y2 Feedback circuit input
C3 23 Current path 2A (relay contacts)
(not connected)
(not connected)
24 Current path 2B (relay contacts)
Observe the technical data of the electrical connections�
(→ 8 Technical data)
PELV power supplies are to be used according to EN 60204-1�
The electrical input signals meet the requirements to EN 61131, type 2�
Do not use unconnected terminals as support point terminal�
Terminal tightening torque: 0�6���0�7 Nm (5���7 lb-in)�